B1701 Isuzu the main thing to check is to verify the operation of the VCT solenoid. You're looking for a sticking or stuck VCt solenoid valve caused by contamination. Refer to vehicle specific repair manual to perform component tests for the VCT unit.
Remove the air filter box assembly so you can access the transmission range switch. Turn the key to the ON position, but do not start the vehicle. Move the shifter to the neutral position. Align the alignment holes between the switch and the shift lever. Insert a 5mm drill bit into the adjustment hole to verify the proper alignment for the neutral position.
Indicator and headlight bulbs need regular maintenance for them to keep functioning properly. Also the car paint ought to be in good condition because that reduces the chances of rust taking over the body of your car. This is one of those car maintenance problems, which are easy to handle, given the variety and quality of products available in the market today.
B1701 meaning and repair processes are the same for all Isuzu models.
B1701 Isuzu Trouble Repair Process:
B1701 Isuzu code shows that location the body harness connector, located in and around the left hand kick panel area or inside the IP (consult a shop manual for location). Water can leak into the connector from clogged sunroof drains, A-pillar leaks, or windshield or cowling leaks.
b1701 is a very common fault code for the thermostat. If you have this fault it will need to be replaced. I would start with that repair, clear the faults and perform a 30 minute battery reset(disconnect the negative cable off of the battery) and retest the vehicle.